patch-2.2.8 linux/Documentation/sound/OPL3-SA

• Lines: 37
• Date: Thu Apr 29 11:53:41 1999
• Orig file: v2.2.7/linux/Documentation/sound/OPL3-SA
• Orig date: Tue Feb 23 15:21:32 1999

diff -u --recursive --new-file v2.2.7/linux/Documentation/sound/OPL3-SA linux/Documentation/sound/OPL3-SA
@@ -15,7 +15,7 @@
 You'll need to know all of the relevant info (irq, dma, and io port) for the
 chip's WSS mode, since that is the mode the kernel sound driver uses, and of
 course you'll also need to know about where the MPU401 and OPL3 ports and
-irq's are if you want to use those.
+IRQs are if you want to use those.
 
 Here's the skinny on how to load it as a module:
 
@@ -24,14 +24,14 @@
 Module options in detail:
 
 	io:	This is the WSS's port base.
-	irq:	This is the WSS's irq.
-	dma:	This is the WSS's dma line. In my BIOS setup screen this was
+	irq:	This is the WSS's IRQ.
+	dma:	This is the WSS's DMA line. In my BIOS setup screen this was
 		listed as "WSS Play DMA"
-	dma2:	This is the WSS's secondary dma line. My BIOS calls it the
+	dma2:	This is the WSS's secondary DMA line. My BIOS calls it the
 		"WSS capture DMA"
 	
 	mpu_io:	This is the MPU401's port base.
-	mpu_irq: This is the MPU401's irq.
+	mpu_irq: This is the MPU401's IRQ.
 
 If you'd like to use the OPL3 FM Synthesizer, make sure you enable
 CONFIG_YM3812 (in 'make config'). That'll build the opl3.o module.
@@ -43,7 +43,7 @@
 
 Say 'y' or 'm' to "SoftOSS software wave table engine" in make config.
 
-If you said yes, the software synth is availible once you boot your new
+If you said yes, the software synth is available once you boot your new
 kernel.
 
 If you chose to build it as a module, just insmod the resulting softoss2.o